[Nicola]

I did more tests, including resetting the board.
I tried having the board on standard http port 80, and a different one (my preference).
Blynk port always set to default 80.

My finding: blynk works all the time, from local network and from outside.
Mobile app works only from local network. The moment I turn off wifi in my phone it stops working.
I tried to set play with various OG Mobile app as connection type:

“local only”, obviously works only from local lan, and it does.
“local + cloud”, works from local lan, but not from outside. No particular error messages.
“cloud only” gives an error message: invalid blynk token. But this cannot be, as blynk app works always fine, and OG mobile app actually shows me the very same token that I can see from the web page and that makes blynk work correctly.

Could it be that my particular token begins with a ‘-‘ (minus) character, and the app for some reason does not digest it?
And/or, how do I generate a new token? I could not figure it out.

Please assist, thanks!

[Nicola]

Same problem here, but I cannot scan the one linked in the manual either!

https://raw.githubusercontent.com/OpenGarage/OpenGarage-Firmware/master/OGBlynkApp/og_blynk_1.1.png

does not work.

[Nicola]

Re: 3: my automatic gate is one of those villa/garden two sides heavy metal gates with hydraulic arms, and works like this: push N.O. button once (close contact for a few ms, 1 sec is also ok), sides of the gate open and continue open after you release the button; after 1-2 minutes they close on their own. if you press button again while they are closing, they stop and reopen again.
So I just want to make sure, can OG mimic just the open action for a few ms/1 sec and that’s it?
For the monitor, as the ultrasound would not work and OG is not waterproof, I would put it in an sealed box, and connect to it an external magnetic sensor that closes contact when the two sides of the gate are closed.Is this also possible?

[Author]

Posts