Viewing 1 post (of 1 total)
  • Author
    Posts
  • #334

    Nick
    Participant

    Went through the instructions and had some trouble scanning the QR code. Finally that bit worked. Local web control works to open and close the garage. But although Blynk has the project it did not actually see a device. Added one manually but none of the pins are configured. Manually setup GPIO 15 for the relay and that bit is working. Now just trying to figure out the pinouts from the GiT docs to get the other bits working. I would delete the project and start over but trying not to lose Blynk energy. Anyone else see a weird issue like this?

    Update. Added a second device Am wondering what I am missing on the install. Blynk is seeing the device just not including the pinout config.

    Update: RTFM just read https://opengarage.io/forums/topic/blynk-not-connecting/#post-313 Same issue here thanks Ray for posting the pinouts.

    • This topic was modified 7 years, 9 months ago by Nick.
    • This topic was modified 7 years, 9 months ago by Nick.
    • This topic was modified 7 years, 9 months ago by Nick.
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.