Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 27, 2018 at 4:47 pm in reply to: Fork with MQTT, Magnetic Sensor support ,Close if left open at night – misc #996

    andyss
    Participant

    I think it’s working pretty okay with just TLS certs and without user/pass enabled. I will delve into it a bit more when I get a chance to see if there are any errors, etc. Compiling, yeah no. Over my head unfortunately.

    Andy

    February 24, 2018 at 2:57 pm in reply to: Fork with MQTT, Magnetic Sensor support ,Close if left open at night – misc #981

    andyss
    Participant

    Thanks @lawrence_jeff. The open/close/click messages work perfectly. I’m not connecting to an open broker, I have mosquitto installed on a VM with port 8883 open for owntracks using TLS + auth, and everything in my network including the OG unit connecting to 1883 locally. Mosquitto, to my knowledge, only allows anon access (no user/pass) on all listening ports or none at one time. I’ve disabled user/pass for the time being but it would be a nice to have to make everything consistent and more secure for me.

    Thanks again.

    Andy

    February 23, 2018 at 6:13 pm in reply to: Fork with MQTT, Magnetic Sensor support ,Close if left open at night – misc #977

    andyss
    Participant

    Hi all, just got my unit and playing around with it before I mount it in the garage. A few questions if anyone can help me out with an mqtt config (@lawrence_jeff). I’m successfully receiving messages to my broker (mosquitto). Can I send messages to open and close the door (activate relay) via mqtt? What are the commands / topics? Also, is username / password authentication for mqtt available or planned?

    Thanks for the great work you guys are doing.

    Andy

    (Firmware 1.0.8)

    • This reply was modified 6 years, 11 months ago by andyss.
    • This reply was modified 6 years, 11 months ago by andyss.
  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)