Hi lawrence_jeff,
during this week-end i think to receive a new official opengarage and i try to mount the sensor, and of course i send you some picture.
the GPIO4 and GND contact are located on the LEFT-TOP of the device.
i have installed your firmware on my actual opengarage and seems to work very well and much better than original firmware, but the interface have some difference with your screens
hot, for example i cant see VEHICLE TRESHOLD field, it’s normal?
Some of the screenshots in the master branch are actually code that is in the dev branch of my repository. It adds a number of features around vehicle detection and use of the additional GPIO pins for temperature or secondary door measurements. It isn’t quite stable yet so I haven’t prompted it to the Master (the pictures were a mistake)
Is there a particular aspect you are interested in – I can get that into the master branch?