- This topic has 1 reply, 2 voices, and was last updated 5 years, 5 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hello.
Anyone here who got a link to where I can buy the following components for OpenGarage:
D2 – 3v3 Zener SMD diode?
OPENER – 2 pole screw terminal somehow?
RELAY: Some spesifics on which relay is used? (default state e.t.c.?)The zener diode is actually not necessary — the only diode you need is the one for the relay, which serves as a flywheel diode.
Any 5mm/5.08mm terminal block would fit (or you don’t really need a terminal block, you can just solder two wires onto the terminal block pins).
Relay: the one we use is HK23F-5V. Pretty much any relay would work fine — garage door systems actually use fairly low voltage (often 12VDC) while typical relays are rated for at least 110V, so the requirement on the relay is very low.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.